Skip to the content
stage-check Help Mac beta coming soon

stage-check / Help

Projector keeps disconnecting from the MacBook

The projector shows your screen for a few seconds, drops to no signal, comes back, and repeats. It happens on more than one cable and more than one port. That pattern usually points at something in the venue's chain, not your cable.

Fix it by hand, in this order

  1. Try the other port and cableMove to a different port on the Mac and a different cable. If it flickers the same way on both, the cable is probably not the cause.
  2. Remove hubs and extra adaptersUse one direct cable or one adapter, not a chain. Fewer parts means fewer places to fail.
  3. Try a USB-C to HDMI adapterA university IT guide says an adapter in this position negotiates HDCP in place of the Mac and may make a stubborn setup work.
  4. Tell AV what you seeSay it plainly: your laptop keeps being dropped by their switcher, and it looks like an HDCP handshake failure. Ask whether they can put an HDMI splitter or scaler in front of it.
  5. Offer to use the house computerIf they cannot fix it in time, ask to use their computer and open your demo from a link or a file on a drive.

Why it happens

At a venue on 2026-11-14 a MacBook Pro was plugged into the venue's switcher by HDMI and by USB-C, and neither worked. The Mac's log shows macOS added a 1080p display named BMD HDMI (vendor Blackmagic Design) and lost it again nine times in seventeen minutes, in two bursts, on both ports. During that time it logged 282 hot-plug interrupts (IRQ_HPD) and 275 HDCP aborts. The log shows these together. It does not prove which caused the other, and it had no healthy-monitor baseline to compare against.

Longer guides

What stage-check does about it

stage-check watches the screens from the moment it launches. Two removals in five minutes is a NO-GO, with a line to say to AV. One blink is a WARN. A screen that has just appeared stays at CHECKING, never GO, until it has stayed up for 120 seconds. HDCP abort counts from the log are shown as evidence only, not as a verdict.

The Mac beta is coming soon. Failure modes: VG01, DV09.

Questions

Why does my projector keep cutting out?

Candidates in the sources are a marginal cable or adapter, and a switcher or extender that fails the HDCP handshake. At one venue the Mac logged 275 HDCP aborts while the screen dropped nine times, but the log does not prove HDCP was the cause.

Does switching to a different cable help?

Sometimes. Several users in one Apple Community thread said a new cable fixed an undetected display. If the screen drops the same way on two different ports and cables, the venue's gear is the likelier problem.

Sources

Every claim on this page traces to a source above that was opened and read on 2026-11-15. Search results that were not opened are not cited.