Skip to the content
stage-check Help Mac beta coming soon

stage-check / Help

MacBook HDMI connected but no signal on the projector

The projector says no signal and System Settings > Displays shows only your built-in screen. The cable is in, but the Mac never agreed on a picture with the other end. Cables, adapters and the venue's own gear are the usual suspects.

Fix it by hand, in this order

  1. Reseat the cable and detectUnplug the cable, plug it back in, then open System Settings > Displays, hold the Option key and click Detect Displays. Some people report that Detect Displays changed nothing, so do not stop here.
  2. Swap the cableTry a different cable, ideally a short one of good quality. Several people in one Apple Community thread said a new cable fixed it.
  3. Power-cycle the projectorTurn the projector off and on again with the Mac connected. One user in that thread said this made the screen appear.
  4. Try a USB-C to HDMI adapterIf you are going straight from the Mac's own port, a USB-C to HDMI adapter sits between the Mac and the venue's gear. One university IT guide says this often makes the setup work.
  5. Ask AV about an EDID emulatorIf the adapter fails, tell the AV person your laptop is getting no picture through their chain. The same IT guide says an EDID emulator in line can stabilise it.

Why it happens

A Mac asks the display what it can do (EDID) and may also negotiate HDCP copy protection. A university IT guide says M1, M2 and M3 MacBooks are far less forgiving than Windows PCs about both, and that an old or non-standard AV chain may return bad or incomplete EDID, so the Mac refuses the signal. Reports of the same symptom after a macOS update, and fixes by cable replacement, are anecdotal and not confirmed by Apple.

This is the short version. MacBook on HDMI, and the projector says no signal is the full guide, with 10 fixes in order and what to say to AV.

What stage-check does about it

stage-check watches the screen count against the number you said to expect and tells you when macOS sees fewer. It also reports 'cable seen, handshake failing' when the cable shows signs of life for about ten seconds and no screen ever arrives. It does not fix the handshake. It tells you which one it is so you can say it to the AV person.

The Mac beta is coming soon. Failure modes: DV01, DV04.

Questions

Why does my M-series MacBook fail when other laptops work on the same projector?

One university IT guide says M1, M2 and M3 MacBooks are far less forgiving than Windows PCs about EDID and HDCP handshakes, so an old scaler can pass a Windows laptop and fail a Mac. It is a single guide, not a measurement.

Does Detect Displays fix it?

Apple says that if your Mac does not recognise a connected display, holding Option shows a Detect Displays button. In one Apple Community thread a user reported it changed nothing, so treat it as a first try, not a fix.

Sources

Every claim on this page traces to a source above that was opened and read on 2026-11-15. Search results that were not opened are not cited.